Duerkopp Adler 367 Instructions d'exploitation télécharger pdf (Page 30)

8. EFKA VD552KV/6F82FA coupling-positioning actuator

8.1 General

Operation

The VD552KV/6F82FA sewing-drive control contains an integral

“operating panel” with 5 keys, 8 LEDs and a three-digit LED display. All

required adjustments to the sewing-drive control can be carried out

with this operating panel. The V810 or V820 operating panel can also

be connected to the control. In this case the integral operating

elements are ineffective.

Operating instructions

The functions of the operating elements of the 6F82FA sewing-drive

control are described below, together with the procedure for the

alteration by the operator of operator-level parameter values.

For a detailed description of the 6F82FA control please see the “EFKA

6F82FA” operating manual:

V810 operating panel - see section 7.2

V820 operating panel - see section 7.3.

Functions of the 6F82FA sewing-drive control

The functions of the 6F82FA sewing-drive control are determined by

the program and the parameter settings. When parameter values are

correct the control is properly set for the relevant class and subclass.

Actuator parameter values are pre-set by EFKA prior to delivery.

Certain parameters must be altered for each class and subclass: see

the set-up instructions. All parameters are correctly set on delivery.

Access authorisation for command entry

To prevent the unwanted alteration of pre-set functions there are three

levels of command entry. These are as follows:

-themanufacturer has access to the highest level and all

subordinate levels with a code number. “manufacturer level”

-thetechnician has access to the two lower

levels with a code number. “technician level”

-theoperator has access to the lowest level with no code number.

“operator level”

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 38 39

Pas de commentaire

Duerkopp Adler 367 Instructions d'exploitation Page 30