Duerkopp Adler 367 Instructions d'exploitation télécharger pdf (Page 29)

7.5 Status and error messages on the V810 and V820 operating panels

General information

V810 V820 Meaning

InF A1 InFo A1 The pedal is not in its z ero position w hen the

sewing drive is switched on

StoP symbol “G”

flashes “cut-out”

flashes

The cut-out is active

InF A3 InFo A3 Reference position not stored.

For programming see set-up instructions.

InF A5 InFo A5 No valid Autoselect resistance

detected. For information see set-up

instructions

Programming error message

V810 V820 meaning

If InFo F1

jumps back

to 1st digit

Incorrect code or parameter number

entered

Hardw are and softw are error messages

V810 V820 meaning

InF E1 InFo E1

After main sw itch on:

proximity or commutation switch

defective or connection lead wrongly connected.

During or after a sew ing run:

proximity switch defective.

InF E2 InFo E2 Mains voltage too low or the time between

main switch OFF and main switch ON was

too short.

InF E3 InFo E3 Machine is blocked or not reaching the

required rotation speed

InF E4 InFo E4 Control disrupted by defective earthing

or defective plug connections

(contact error).

InF H1 InFo H1 Commutation-switch lead is defective or

the power electronics for the generation of the

rotating field is faulty.

InF H2 InFo H2 Processor faulty.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 38 39

Pas de commentaire

Duerkopp Adler 367 Instructions d'exploitation Page 29