Duerkopp Adler 367 Instructions d'exploitation télécharger pdf (Page 23)

7.2.4 Changing operator-level parameter values

The operator-level parameters are in the parameter list (see

section 7.4).

–

Turn on the main switch.

–

Press the “P” k ey. The first operator-level parameter F-000 is

displayed.

–

Press the “+”or“-” keys to move to the next or preceding

para me ter.

–

Press the “E” k ey. The value of the selected parameter is

displayed.

–

The parameter value can be changed with the “ +” and “-”keys.

–

Press the “E” k ey to save the change and display the next

para me ter,

or press the “P” key twice to save the change and leave

programming level.

CAUTION:

The changed parameter values are not saved unless a complete

seam is sew n after leaving programming level, i.e. the pedal is

pushed forw ards and then all the w ay back. If the drive is

sw itched off straight after leaving programming level, the changes

are lost.

7.2.5 Reducing the maximum rotation speed

The maximum speed can be reduced to adapt it to particular

applications.

The current maximum speed is shown in the display after each seam

has been completed. This value can now be directly changed with the

“+” and “-” keys. The adjustment range lies between the values of

parameters F-111 (maximum value) and

F-121 (minimum value).

Caution:

Reducing the maximum rotation speed also reduces the rpm for

starting and ending bar tacks and f or counted seam sections

executed automatically.

7.2.6 Entering the technician-level code number:

(see set-up instructions)

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 38 39

Pas de commentaire

Duerkopp Adler 367 Instructions d'exploitation Page 23